



Instructions
1) Complete your Cross-stitch design as per instructions in kit.
2) Trim embroidery to within 4cm (1.5") of cross-stitching along the top and bottom edges.
3) Using the holes on the Aida as a guideline turn in 1.5cm (0.5") along the top and bottom edges,
press & tack into place.
4) Centre the sampler across the middle of one of the large pieces of fabric (right-side facing).
5) Machine or handstitch
sampler to fabric along top & bottom edges.
6) Turn over the fabric so wrong side is facing. Along the top edge fold over 1cm (0.25")
then another 2cm (1") - stitch to make a hem. Repeat on second large piece of fabric.
7) Place the two pieces of fabric right-sides together and stitch along bottom and side edges leaving 2cm (1")
seam allowance, making sure the cross-stitch sampler is caught within the seam.
8) To make casings for the cord,
take the 2 small pieces of fabric, fold over 2cm (1") on each short end (to fit the width of the bag) and stitch to neaten. Fold back 0.5cm (0.25") along top and bottom edges, press or tack in place.
9) Turn bag right-side out. Cut the length of cord in half, place one length of cord across the width of the bag
5cm (2") from the top leaving 15cm (6") spare at right-hand-side. Take this piece of cord across the back of the bag 5cm (2") from the top to match front leaving 15cm (6") spare at right-hand-side.
10) Repeat with second piece of cord leaving the spare 15cm (6") on the left-hand-side.